The TwinClip is designed specifically for mounting an Astera or Amaran tube with the use of a Spigot, or by screwing or sticking to flat surface.
 
These TwinClip's utilise our SpigotClip's which are fixed to the main body using 1/4-20 countersunk bolts. Doing this not only makes the TwinClip stronger than the provious version but it also means the Clips can be either removed from the main base and used individually with spigots or by rotating the Clip's 90 degrees making the TwinClip able to hold two tubes side by side.
 
A rubber grip and a slot for a cable tie in the clip helps to hold the light securely in place.
 
Holes in the main body are large enough for a safety chain to be fitted when needed.
 
Note. 
The 'Natural' colour allows for some light transfer, meaning the clip is not as noticable if used on camera.
 
As with all our 3D printed products, being plastic, care must be taken when fitting. Damage caused by heavy handling will not be replaced free of charge.
 
Need a replacement clip? Take a look at our SpigotClip's
 
IPO REGISTERED DESIGN NUMBER - 6289683